RETURN POLICY:
ALL GARMENTS ARE SIZED ACCORDING TO AN ACCURATE SIZING CHART.
PLEASE READ THE FITTING INSTRUCTIONS. IF YOU HAVE ANY QUESTIONS
ABOUT FITTING INTO YOUR GEAR OR FOR RETURN AUTHORIZATION CALL 1-
RETURNED GARMENTS FOR EXCHANGE
MUST INCLUDE $7.50 SHIPPING (AIR SHIPPING EXTRA)
AND MUST BE RETURNED WITHIN 30 DAYS OF SHIPPING DATE,
UNUSED, UNALTERED, UNWASHED, with NO DIRT or GROUND IN POWDER, and NO BODY ODOR.
FITTING INSTRUCTIONS FOR :
THE CRAIN CX-
POWERSUIT®, GENESIS POWERSUIT®
AND GENESIS DEADLIFT SUIT
US TRADEMARK REGISTRATION #1544517
CAUTION:
The suit provided has been carefully selected to match your height, weight and thigh measurements following a sizing chart developed over many years in powerlifting. However, since there is a chance you may wish to exchange this suit for a different size, special care should be taken when trying it on for the first time. Do not use chalk, powder or oil on your body, keep hands clean, etc. To be exchangeable the suit must be returned to us in resaleable condition (in the same condition in which it was shipped to you). Laundered suits will not be exchanged. Your training partner may need to assist you to properly fit your suit.
LEGS:
1. Insert your hands into the leg opening and slowly pre-
2. Slowly pull on the suit until the pant legs stop above the knees.
3. Turn the suit inside out, with the shoulder straps hanging toward the floor
(leave the pant legs where they stopped above the knee).
4. Grab the cuff of the leg (one leg at a time) and work each leg past mid-
When both pant legs are at mid-
5. While you are pulling up the front of the suit, your partner can pull up the back and sides. This is an important step. It’s purpose is to fit the suit properly on the lower body with NO GAP BETWEEN THE BODY AND MATERIAL IN THE CROTCH. It will also insure that all of the slack is out of the lower half of the suit before you attempt to slip into the shoulder straps.
IMPORTANT: Be sure the sides, back and front of the suit have been pulled as high as possible on the body before attempting to put on the shoulder straps.
STRAPS:
6. One side at a time. Your training partner should now pull up the strap enough to allow you to slide your hand down your side towards the opening. (Straps should be pulled up and
SLOWLY STRETCHED -
7. When your hand is even with the armhole, your training partner should pull the strap over the shoulder while you put your elbow through. You will need to dip your shoulder into the strap. Again, do not jerk the strap or pull them way off to the side.
FITTING:
8. You may experience some tightness under the arm or on the lats. If so, have your training partner insert his hands under the material and push it out and up. Repeat this procedure for the opposite side. Make other necessary adjustments by moving the straps on the traps.
9. Relieve tightness on the chest by pushing out and up as if rolling the suit over your shoulders towards the back.
10. When your suit is on and properly fitted you will still experience some tightness on the thighs, shoulders, and perhaps the torso. Continue to wear the suit for at least 15 to 20 minutes without lifting and you will notice it will become more conforming to your body’s
contours.
Care Instructions:
Machine wash in cold water, dry on permanent press cycle.
Make sure to wash garments after EVERY use.
IF YOU HAVE ANY QUESTIONS
PLEASE CALL US AT CRAIN’S 1-